![]() ![]() Sensors – G-Sensor on HPS, temperature Sensor on FPGA.2 HPS Reset Buttons (HPS_RSET_n and HPS_WARM_RST_n).Audio – 24-bit CODEC, Line-in, line-out, and microphone-in jacks.Display – 24-bit VGA DAC, 128×64 dots LCD Module with Backlight.One LTC connector (One Serial Peripheral Interface (SPI) Master ,one I2C and one GPIO interface ).One HSMC (8-channel Transceivers, Configurable I/O standards 1.5/1.8/2.5/3.3V).USB to UART (micro USB type B connector).USB 2.0 OTG (ULPI interface with micro USB type AB connector).On-Board USB Blaster II (micro USB type B connector).Quad Serial Configuration device – EPCQ256 for FPGA.ARM-based hard processor system (HPS) 800 MHz, Dual-Core ARM Cortex-A9 MPCore Processor with 512 KB of shared L2 cache, 64 KB of scratch RAM, Multiport SDRAM controller (DDR2, DDR3, LPDDR1, and LPDDR2), and 8-channel direct memory access (DMA) controller.FPGA Device – Cyclone V SX SoC-5CSXFC6D6F31C8NES:. ![]() Here are the specifications listed on Terasic website: There seems to be a lot a development going on around dual core A9 + FPGA SoCs from Xilinx or Altera these days, and Terasic has recently announced SoCKit, a development board based on Altera Cyclone V SX SoC with 2GB RAM (1GB for ARM cores, 1GB for FPGA), 110K logic elements, etc… Terasic SoCKit Development Board (Click to Enlarge)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |